It has been recorded by the Health & Safety Executive that 25% of all reported electrical accidents are a result of a faulty portable appliance. The Electricity at Work Regulations apply legal responsibility on employers and employees in order to act accordingly with the provisions of regulations and take reasonable steps to ensure that accidents do not result from the use of a portable appliance, which is why it is important to complete PAT appliance testing. It is imperative that a PAT test is completed in order to maintain the health and safety at work. A PAT test depends on the risk of the appliance becoming faulty.
The National Association of Professional Inspectors and Testers (NAPIT) defines a portable appliance as “any electrical item which is intended to be moved whilst connected to an electrical supply”. The IEE Code of Practice highlights regulations on what type of PAT test a certain appliance requires because the type of PAT test is carried out varies depending on the size and usage of an appliance. An appliance which weighs less than 18kg requires a PAT test to ensure that an appliance is able to move from one place to another whilst in use, this includes:
• Hand – Held PAT test – these are appointed to be held during normal use, e.g. a hair dryer.
• I.T PAT test – such as computers and mains powered photocopiers.
How is a PAT test completed? A PAT test is completed by a qualified PAT tester or a trained PAT tester and there are several procedures involved when in order to complete a PAT test.
One method of PAT test is through visual inspections where the PAT tester visually scrutinizes an appliance, in particular the plug and cables will endure testing for any clear signs of hazard. This is an affective method doing a PAT test because according to the HSE this approach to PAT test can find more than 90% of faults, thus, it is a vital mechanism for the maintenance of a electrical appliances. Additionally, a PAT test can be completed through user checks. This procedure is where users are advised on how to avoid any potential danger, for example, a frayed cable or cracked plug. If this is the case then PAT testers advise that the plug is not to be tampered with.
Moreover, a PAT test can be completed through combined inspections and are done at periodical intervals where it is vital that appliance testing is measured at the degree of protection to maintain adequacy. During these intervals a formal visual inspection is completed followed by a PAT test. When completing a PAT test it is essential that the interior of the plug is checked (unless it is molded or sealed), in this case of appliance testing bad internal wiring or an unsuitable fuse would classify the item as hazardous.
In the formal inspection of PAT test there are certain signs to be aware of:
• Disturbance to the power cable sheath
• Wreckage of the mains plug
• Damage to external casing of the equipment, or loose parts and/or screws
The formal PAT test should also contain removal of the plug cover and an analysis of:
• The sufficient value fuse being used
• The cord grip has a tight hold of the outer part of the cable
• The Live, Neutral and Earth wires are attached to the correct terminals
• No visible bare wires
• Tight and secure screwing of the terminal screws
• Signs of internal drainage